Appearance
Validate and Apply a Configuration
Check a saved configuration revision and explicitly apply it to a supported idle workstation.
Before you start
Save the draft first. Validation applies to an exact revision; later edits require another check. Offline-only profiles cannot be applied. Resolve active runs or resource blockers before attempting application.
With your AI agent
Validate the latest saved revision of this configuration and explain errors and warnings. Check its container bindings against the experiment I intend to run. Do not apply it yet.
After reviewing the target revision and changes:
Apply the configuration revision we just validated to the current idle workstation. Check the original application request and read back the active configuration to confirm the outcome.
The agent should use the current configuration identity when applying. On a conflict or uncertain result, read status first rather than retrying with a new request identifier.
In the interface
- In the advanced layout editor, choose Save changes.
- Choose Check layout. Resolve errors, save and check again as needed.
- Confirm the target workstation and select Apply the checked setup to the idle station.
- Choose Apply layout and wait for the outcome.
- If the request is unresolved, choose Inspect application status.
What counts as complete
The application receipt must show completion, and the active configuration read back from the workstation must match the intended change. A saved draft, successful validation or accepted request alone is not completed application.
Static configuration checks do not replace program preflight or physical calibration. After applying, check the experiment against the new configuration.